Connecting the Switch
Switch To End Node
Switch to Hub or Switch
Connecting To Network Backbone or Server
Switch to End Node
End nodes include PCs outfitted with a 10, 100 or 1000 Mbps RJ 45 Ethernet Network Interface Card (NIC) and most routers.
An end node can be connected to the Switch via a twisted-pair UTP/STP cable. The end node should be connected to any of the
1000BASE-T ports of the Switch.
The Link/Act LEDs for each UTP port will light green or amber when the link is valid. A blinking LED indicates packet activity
on that port.
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
NOTE: All high-performance N-Way Ethernet ports can support both MDI-
II and MDI-X connections.
Figure 3- 1. Switch connected to an end node
Section 3
10