D-Link DES-6500 - Switch User Manual page 105

The following parameters can be set, for IP:
Parameter Description
Type in a unique identifier number for this profile set. This value can be set from 1 - 8.
Profile ID (1-8)
Type Select profile based on Ethernet (MAC Address), IP address, Packet Content Mask or IPv6. This
will change the menu according to the requirements for the type of profile.
Class Checking this field will instruct the Switch to examine the class field of the IPv6 header. This
class field is a part of the packet header that is similar to the Type of Service (ToS) or
Precedence bits field in IPv4.
Flowlabel Checking this field will instruct the Switch to examine the flow label field of the IPv6 header. This
flow label field is used by a source to label sequences of packets such as non-default quality of
service or real time service packets.
Source IPv6 The user may specify an IP address mask for the source IPv6 address by checking the
Mask corresponding box and entering the IP address mask.
Destination IPv6 The user may specify an IP address mask for the destination IPv6 address by checking the
Mask corresponding box and entering the IP address mask.
Click Apply to implement changes made.
To establish the rule for a previously created Access Profile:
To configure the Access Rule for Ethernet, open the Access Profile Table and click Modify for an Ethernet entry. This will
open the following screen:
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Figure 6- 58. Access Profile Configuration window (IPv6)
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet header.
•
Select IP to instruct the Switch to examine the IP address in each frame's header.
•
Select Packet Content Mask to specify a mask to hide the content of the packet header.
•
Select IPv6 to instruct the Switch to examine the IPv6 part of each packet header.
•
90