Parameters Description - D-Link DES-6500 - Switch User Manual

To remove a previously created rule, select it and click the
To set the Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameters Description
Profile ID This is the identifier number for this profile set.
Mode Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the Switch
and will be filtered.
Access ID Type in a unique identifier number for this access. This value can be set from 1 - 65535.
Type Selected profile based on Ethernet (MAC Address), IP address, Packet Content Mask or IPv6.
This parameter can be specified to re-write the 802.1p default priority previously set in the
Priority (0-7)
Switch, which is used to determine the CoS queue to which packets are forwarded. Once this
field is specified, packets accepted by the Switch that match this priority are forwarded to the
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Figure 6- 59. Access Rule Table
Figure 6- 60. Access Rule Configuration window - Ethernet.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
•
IP instructs the Switch to examine the IP address in each frame's header.
•
Packet Content Mask instructs the Switch to examine the packet header.
•
IPv6 to instructs the Switch to examine the IPv6 part of each packet header.
•
button. To add a new Access Rule, click the Add button:
91