D-Link DES-6500 - Switch User Manual page 107

CoS queue specified previously by the user.
replace priority − Click the corresponding box to re-write the 802.1p default priority of a packet to
the value entered in the Priority field, which meets the criteria specified previously in this
command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have its
incoming 802.1p user priority re-written to its original value before being forwarded by the Switch.
For more information on priority queues, CoS queues and mapping for 802.1p, see the QoS
section of this manual.
VLAN Name Allows the entry of a name for a previously configured VLAN.
Source MAC Source MAC Address - Enter a MAC Address for the source MAC address.
Destination MAC Destination MAC Address - Enter a MAC Address mask for the destination MAC address.
802.1p (0-7) Enter a value from 0-7 to specify that the access profile will apply only to packets with this 802.1p
priority value.
Ethernet Type Specifies that the access profile will apply only to packets with this hexadecimal 802.1Q Ethernet
type value (hex 0x0-0xffff) in the packet header. The Ethernet type value may be set in the form:
hex 0x0-0xffff, which means the user may choose any combination of letters and numbers
ranging from a-f and from 0-9999.
Port The Access Rule may be configured on a per-port basis by entering the port number of the line
card in the chassis into this field. The port list is specified by listing the lowest line card number
and the beginning port number on that line card, separated by a colon. Then the highest line card
number, and the highest port number of the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a dash. For example, 1:3 specifies line
card number 1, port 3. 2:4 specifies line card number 2, port 4. 1:3 - 2:4 specifies all of the ports
between line card 1, port 3 and line card 2, port 4 − in numerical order. Entering all will denote all
ports on the Switch.
To view the settings of a previously correctly configured rule, click
In the Configuration folder, click the Access Profile Table link opening the Access Profile Table. Under the heading Access
Rule, clicking Modify, will open the following window.
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Figure 6- 61. Access Rule Display window (Ethernet)
in the Access Rule Table to view the following screen:
92