Every Week; Running Belt; Running Deck - Horizon Fitness Horizon T81 User Manual

I i ii
i i i
i i
in
Cleanliness of your treadmill and its operation environment will keep maintenance problems and service calls to a
minimum. For this reason, we recommendthat the following preventive maintenanceschedule be infiowed.
AFTEREACH USE(DALLY)
Cleanand inspect, following these steps:
• Turnoff the treadmill with the on/off switch, then unplug the powercord at the waft outlet.
• Wipedown the running belt, deck,motor cover,and console casing with a damp cloth. Never use solvents, as they
can cause damage to the treadmill.
• Inspect the power cord. If the power cord is damaged, contact HorizonFitness.
• Make sure the power cord is not underneaththe treadmifl or in any other area whereit can becomepinched or cut.
• Checkthe tension and alignment of the running belt. Make sure that the treadmill belt will not damage any other
componentson the treadmill by being misaligned.
EVERY WEEK
Cleanunderneath the treadmill following these steps:
• Turnoff the treadmill with the on/off switch, then unplug the powercord at the waft outlet.
• Fold the treadmifl into the upright position, making sure that the lock latch is secure.
• Movethe treadmill to a remote location.
• Wipeor vacuumanydust particles or otherobjectsthat mayha veaccumulatedunderneaththe treadmill
• Return the treadmill to its previous position.
EVERY MONTH- IMPORTANT!
• Turnoffine treadmill with theon/offswitch, then unplug thepowercordat the wafloutlet.
• Inspect all assembly bolts of the machine for proper tightness.
• Turnoff the treadmill and wait 60 seconds.
• Removethe motor cover.Wait until aft display screensturn off.
• Clean the motor and lower board area to eliminate any lint or dust particles that may have accumulated. Failure to
do so may result in premature failure of key electrical components.
• Vacuumand wipedown the belt with a damp cloth. Vacuumanyb/acMwhiin nartic/es that may accumulate around
the unit. These particles may accumu/ate from normal treadmill use.
EVERY 6 MONTHS OR 150 MILES
It IS necessaryto lubricate your treadmill runmng deck every six months
or 150 miles to maintain optimal performance.Oncethe treadmill reaches
]50 miles, the console will display the message "LUBE" or "LUBEBELT.
Thetreadmill /viii not operate while the messageis showing. Hold Stop
for 5 seconds to suspend message for 5 miles. Yourtreadmill came with
a bottle of lubricant which can be used for two appfications. If you need
hinricant, contact HorizonFitness. Only use lubricant provided by Horizon
Fitness.
RUNNING BELT
• Turnoffthe treadmill with the on/offswitch, then unplug the power
cord at the waft outlet. RUNNING DECK
• Loosenboth the rear roller bolts. (Forbest restllts, place two removable
marks on both sides of the frame and note roller position). Oncethe
belt is loosened,take the bottle of lubricant and apply it to the entire
top surface of the running deck. Tightenboth rear roller bolts
(matching up the marks for proper position) to original position. After
you have applied lubricant, ping in the powercord, insert the safety
key,start the treadmill and walk on the belt for two minutes to spread
the lubricant.
• Lubricate the air shocks with Teflonbased spray.
• Oncelubrication is complete, reset the consoleby pressing and holding 'STOP' a nd Speed '+' buttons for 5 seconds.
Pleasecontact HorizonFitness with questions about applying lubricant to your treadmill.