Table of Contents
Advertisement
CONNECTING
EXTERNAL VIDEO SOURCES
The exact arrangement you use to connect the Video Cassette Recorder, Video Disc Player and Video Camera to your
TV set is dependent on the model and features of each component. Check the Owner's Manual of each component
for the location of its video and audio inputs and outputs. The following connection diagrams are offered as sugges-
tions. However, you may need to modify them to accommodate your particular assortment of components and fea-
tures. For best performance, video and audio cables should be made from coaxial shielded wire.
Before Operating External Video Source
The input mode is changed every time the INPUT button is pressed as shown below. Connect external source to the
INPUT terminal, then press the INPUT button as necessary to view the input source. (See page 28.)
INPUT MODE SELECTION
ORDER
{Antenna)
!lnput)
121
_I
VIDEO
NOTE:
When the TV is set to "VIDEO" and a video signal is not received from VIDEO INPUT JACK on the jack
panel of the TV (i.e., VCRNideo
Disc Player, etc. is not connected or the video device is OFF), the
screen will be grey-blue.
CONNECTING
MONAURAL AUDIO VCR OR VIDEO DISC PLAYER
1. Connect the cable from the VIDEO OUT of the VCR or the Video Disc Player to the INPUT (VIDEO) jack on the TV
set. (Fig. 1)
2. Connect the cable from the AUDIO OUT of the VCR or the Video Disc Player to the INPUT (MONO)/L(AUDIO)
jack.
3. Press the INPUT button to view the program from the VCR or Video Disc Player. The mode "VIDEO" disappears
automatically after approximately 8 seconds.
4. Press the INPUT button to return to the previous channel.
5. See below.
Video Cassette Recorder
TV INPUT
'ERMINAL
INPUT
VIDEO
MQNO)
AU DIO
f
",,,,
VIDEO
OUT
AUDIO
OUT
II I I
FIG. 1
22
Advertisement
Table of Contents
