Connecting External Video Sources - Hitachi 32UDX10S, 36UDX10S Operating Manual

Solid state color tv

Table of Contents

The exact arrangement you use to connect the VCR, camcorder, laserdisc player, DVD player, or HDTV Set Top Box to your TV set is

dependent on the model and features of each component. Check the owner's manual of each component for the location of video

and audio inputs and outputs.

The following connection diagrams are offered as suggestions. However, you may need to modify them to accommodate your

particular assortment of components and features. For best performance, video and audio cables should be made from coaxial

shielded wire.

Before Operating External Video Source

The input mode is changed every time the INPUT button is pressed as shown below. Connect an external source to the INPUT

terminal, then press the INPUT button as necessary to view the input source. (See page 24)

When the TV is set to VIDEO and a video signal is not received from the VIDEO INPUT JACK on the back panel of the

NOTE:

TV (i.e., VCR/laserdisc player, etc. is not connected or the video device is OFF), the set will appear to be OFF.

CONNECTING A MONAURAL AUDIO VCR OR LASERDISC PLAYER

Connect the cable from the VIDEO OUT of the VCR or the laserdisc player to the INPUT (VIDEO) jack, as shown on the TV set

below.

Connect the cable from the AUDIO OUT of the VCR or the laserdisc player to the INPUT (MONO)/L(AUDIO) jack.

Press the INPUT button to view the program from the VCR or the laserdisc player. The VIDEO mode disappears automatically

after approximately eight seconds.

Press the INPUT button to return to the previous channel.