Table of Contents
Advertisement
HOW TO USE THE REMOTE TO CONTROL YOUR TV
(_TV
POWER Button
Press this button to turn the TV set on or off.
turned on. (See page 48.)
If ON/OFF TIMER is set, it will be displayed when the TV is first
(_) SLEEP Button
Press this button to displaythe SLEEPTIMER in the lowerleft cornerof the screen. Everysubsequentpressof
this button will add 15 minutes tothe timer,up to a maximumof 3 hours.
(_) MENU, CURSOR
All the On-Screen Display features can be set or adjusted by using these buttons.
The "MENU" button willstartthe On-ScreenDisplay.
The "CURSOR" buttons willhighlight f unctions or adjustand set different features. Pressing the cursorbuttonwill
also give you access to the FAMILYFAVORITESCHANNELS On-ScreenDisplay.
(_
CHANNEL SELECTOR Buttons
Enter two or three numbers to select channels. Enter "0" first for channels 1 to 9.
For channels 100 and above, press the 1 button and wait for 2 seconds before pressing the last two digits of the
channel.
Channel selectionmay also be performed by pressing CH up (&) or down(V).
You may also use these buttons for channel scanning. Press and hold the CH up (A) or down (V) button and
the'IV will start quickly scanning through the channels. Release the CH up (A) or down (V) button when the TV
scans to the channel you wish to watch and the TV will tune to that channel.
I NOTE"
The TV may n°t receive s°me channels if Y°U are n°t in the c°rrect SIGNAL SOURCE m°de'
(See
Ipage 41 .)
(_
INPUT Button
The INPUT button will select between the antenna signal and the video input jacks each time the button is
pressed. If the Picture-in-Picture (PinP) is on, the INPUT will not select any source signal on the main picture.
However, if the PinP is on, the INPUT will alternate between the main signal source and the input source on the
sub-picture. (See graphic below.) (See page 31.)
t
INPUT
INPUT
INPUT
f
_IDEO:I
(S-IN)
I
INPUT
t
VIDEO:2
28
Advertisement
Table of Contents
