Connecting External Video Sources - Hitachi 32GX01B, 32UX01S, 36GX01B, 36UX01S Operating Manual

The exact arrangement you use to connect the VCR, camcorder, laserdisc player to your TV set is dependent on the model and
features of each component. Check the owner s manual of each component for the location of video and audio inputs and outputs.
The following connection diagrams are offered as suggestions. However, you may need to modify them to accommodate your
particular assortment of components and features. For best performance, video and audio cables should be made from coaxial
shielded wire.
Before Operating External Video Source
The input mode is changed every time the INPUT button is pressed as shown below. Connect an external source to the INPUT
terminal, then press the INPUT button as necessary to view the input source. (See page 23.)
When the TV is set to VIDEO and a video signal is not received from the VIDEO INPUT JACK on the jack panel of
NOTE:
the TV (i.e., VCR/laserdisc player, etc. is not connected or the video device is OFF), the screen will be gray-blue.
CONNECTING A MONAURAL AUDIO VCR OR LASERDISC PLAYER
1. Connect the cable from the VIDEO OUT of the VCR or the laserdisc player to the INPUT (VIDEO) jack on the TV set below.
2. Connect the cable from the AUDIO OUT of the VCR or the laserdisc player to the INPUT (MONO)/L(AUDIO) jack.
3. Press the INPUT button to view the program from the VCR or the laserdisc player. The VIDEO mode disappears automatically
after approximately eight seconds.
4. Press the INPUT button to return to the previous channel.

CONNECTING EXTERNAL VIDEO SOURCES

TV INPUT
TERMINAL
VIDEO
(MONO)
L
R
AUDIO
INPUT
16
V CR
VIDEO OUT AUDIO OUT