GE GXSS20H Owner's Manual & Installation Instructions page 17

ge.com
Service: Manually Initiated Electronics Diagnostics
1. To enter diagnostics, press and hold the
SELECTbutton until (000 - -) shows in
the displag.
A The letter(P) and dash(es)indicate
POSITIONswitch operation. The letter
appearing means the switch is closed;
the dash means the switch is open.
Use the TOUCHORHOLD (RECHARGE
Turbine Sv_tches 1
Water Switch
Meter
(not included in
this model)
TONIGHT-RECHARGE NOW) button to manually advance
the valve into each cycle and check correct switch
operation.
CORRECT SWITCH
DISPLAYS
VALVE CYCLESTATUS
Valve in service, fill, brining, backwash
or fast rinse position.
Valve rotating from one position to
another
While in this diagnostic screen,the following information is
available and mag be beneficial for various reasons.This
information is retained by the computer from the first time
electrical power is applied to the control.
?_: P ress and hold the UP button to displag the number
of dags this control has had electrical power applied.
:;;;, P ressand hold the DOWN button to displag the number
of regenerations initiated bg this control since the SR
code number was entered.
2. Pressthe SELECT button and hold in
three seconds until a Service Rating code _wjw wl! bw_
appearsin the displag. ! I C P_
For correct water softening system
operation, the model code must be FT20 for model
GXSS2OH.
To reset the code, press the UP or DOWN button until the
correct number shows.
3. Pressthe SELECT button to return to the present time displag.
If the code was changed, make ALL the timer settings.
NOTE:If the control is left in a diagnostic displag or a
flashing display when setting times or hardness, present time
automatically returns if a button is not pressed within four
minutes.
17