GE 20 Owner's Manual And Installation Instructions page 33

installation instructions
[] FASTEN THE SHUTOFF VALVE
Fasten the shutoff valve to the cold water
pipe with the pipe clamp.
Pipe Clamp x_k
Saddle-Type
Shutoff Valve
Vertical Cold Water Pipe
NOTE: Commonwealth of Massachusetts
Plumbing Codes 248CMR shall be adhered
to. Saddle valves are illegal and use is not
permitted in Massachusetts. Consult with
your licensed plumber.
[] TIGHTEN THE PIPE CLAMP
Tighten the clamp screws until the sealing
washer begins to swell.
NOTE: Do not overtighten or you may
crush the tubing.
Pipe Clamp
Clamp
Washer
Inlet End
[] ROUTE THE TUBING
Route the tubing between the cold water
line and the refrigerator.
Route the tubing through a hole drilled in
the wall or floor (behind the refrigerator or
adjacent base cabinet) as close to the wall
as possible.
NOTE: Be sure there is sufficient extra
tubing (about 8' [2.4 m] coiled into 3 turns
of about 10" [25 cm] diameter) to allow the
refrigerator to move out from the wall after
installation.
[] CONNECT THE TUBING
TO THE VALVE
PUace the compression nut and ferruUe
(sUeeve) for copper tubing onto the end
of the tubing and connect it to the
shutoff vaUve.
Make sure the tubing is fully inserted
into the vaUve. Tighten the compression
nut secureUy.
For pUastic tubing from a GE
SmartConnect
TM
Refrigerator Tubing kit,
insert the roomed end of the tubing into
the shutoff vaUve and tighten compression
nut until it is hand tight, then tighten one
additionaU turn with a wrench.
Overtightening may cause Ueaks.
Saddle-Type
Shutoff Valve
\
Packing Nut
Outlet Valve
Compression Nut
/ SmartC°nnectT"
Tubin0
Ferrule (sleeve)
NOTE: Commonweakh of Massachusetts
Plumbing Codes 248CMR shall be adhered
to. Saddle valves are illegal and use is not
permitted in Massachusetts. Consult with
your licensed plumber.
[] FLUSH OUT THE TUBING
Turn the main water supply on and flush
out the tubing until the water is clear.
Shut the water off at the water valve after
about one quart (1 liter) of water has been
flushed through the tubing.
I To complete the installation of the refrigerator,
go back to Step 1 in Installing the Refrigerator.
33