Erasing Shadows Around The Edges Of A Copy (Erase Copy) - Sharp AR-M161 Operation Manual

ERASING SHADOWS AROUND THE
EDGES OF A COPY
This feature is used to erase shadows that appear around the edges of copies of books and other thick originals.
(Edge erase)
The feature can also erase the shadow that appears down the centre of books and other originals that open up.
(Centre erase)
Both the shadow lines around the edges of copies and the shadow at the centre can be erased. (Edge + Centre erase)
Edge erase
A
A
• Five selections are available for the erasure width: 0 mm, 5 mm, 10 mm, 15 mm, 20 mm (0", 1/4", 1/2", 3/4", 1").
(The default setting is 10 mm (1/2").)
• Centre erase / Edge + Centre erase cannot be used in combination with dual page copy (page 62).
• Edge erase cannot be used in combination with 2 in 1 / 4 in 1 copy (page 66).
• Edge erase cannot be used when paper is fed from the bypass tray.
• Edge erase cannot be used in combination with card shot (page 71).
• Edge erase cannot be used when copying a special size original.
• Note that if the width of the erasure is too large, the edge of the image may be partially erased.
• The default setting for the erasure width can be changed. (Page 86)
1
Place the original in the document
feeder tray or on the document glass.
2
Press the [SPECIAL FUNCTION] key.
2-SIDED
COPY
SPECIAL FUNCTION
DUPLEX SCAN
ACC.
The function screen appears with "SPECIAL MODES"
selected.
3
Press the [OK] key.
BACK OK
GHI
The special modes
screen will appear.
Centre erase
A B
SPECIAL FUNCTION
SPECIAL MODES
ORIG. SIZE ENTER
PAPER SIZE SET
DISPLAY CONTRAST
SPECIAL MODES
MARGIN SHIFT
ERASE
DUAL PAGE COPY
[OK]:ADJUST
Edge + Centre erase
A B
A B
4
Select "ERASE" with the [ ] or [ ]
key.
2-SIDED
COPY
SPECIAL FUNCTION
The edge erase settings
screen will appear.
5
Press the [OK] key.
OK
The edge erase settings
screen will appear.
6
Select the desired erase mode with
the [ ] or [ ] key.
(Erase copy)
A B
SPECIAL MODES
GH
MARGIN SHIFT
PQR
ERASE
DUAL PAGE COPY
[OK]:ADJUST
ERASE
OFF
EDGE
CENTRE
10 mm
"EDGE", "CENTRE" or
"EDGE+CENTRE" can be
selected.
5
(0~20)
69