One-Sided Copies Of Two-Sided Originals; (Only When Using The Rspf) - Sharp AR-M161 Operation Manual

COPY FUNCTIONS

ONE-SIDED COPIES OF TWO-SIDED ORIGINALS

(ONLY WHEN USING THE RSPF)

• Paper sizes that can be used are A3, B4, A4, A4R, B5, B5R, A5, 11" x 17", 8-1/2" x 14", 8-1/2" x 13", 8-1/2" x 11"
and 8-1/2" x 11"R.
• Automatic two-sided copying is not possible when the bypass tray is used.
• This copy function cannot be used in combination with dual page copy.
1
Make sure that an original does not
remain on the document glass, and
then adjust the original guides to the
width of your originals and place the
originals face up in the document
feeder tray.
2
Press the [2-SIDED COPY] key.
TO 2-SIDED
GE OUTPUT COPY
SPECIAL FUNCTI
MAT
ORIGINAL SIZE DUPLEX SCAN
CAST
The duplex mode selection
screen appears.
3
Select "2 to 1" with the [ ] or [ ] key,
or with the [2-SIDED COPY] key.
GH
PQR
2-SIDED
COPY
SPECIAL FUNCTION
60
COPY MODE
1 to 1
1 to 2
2 to 2
COPY MODE
1 to 2
2 to 2
2 to 1
BINDING CHANGE OFF
4
If you wish to have the orientation of
the back image be opposite the
orientation of the front image, set
"BINDING CHANGE" to "ON" with the
[ ] or [ ] key.
If the copies are to be bound at the top, reversing the
orientations of the front and back images will result in a
uniform orientation when the bound copies are viewed (note
that this may depend on the orientation of the originals).
5
Press the [OK] key.
You will return to the base
screen.
BACK OK
GHI
6
Set the number of copies and press
the [START] key (
To stop copying in the middle of
a run, press the [C] key.
WXYZ
Do not touch an original (A) that is on the
Note
reversing tray. Doing so may cause a misfeed.
COPY MODE
1 to 2
2 to 2
2 to 1
BINDING CHANGE ON
).
(A)