Feed Paper To The Label Peeling Position - Epson TM-T88III Programming Manual

C O N F I D E N T I A L
FS ( L <Function 65 >
[Name]

Feed paper to the label peeling position

[Format] ASCII
Hex
Decimal
p p
[Range] ( +
L
m = 48, 49
fn
= 65
[Description] Feeds paper to the label peeling position.
m
48
49
[Notes]
Please use this function by using "the first state of the line" in standard mode.
This function is used only with label paper.
The paper feed operation ends when no paper is detected in the paper feed to the label peeling position.
[Position information A] transmitted by Function 48 becomes (bit 0 = 1) when this function is processed.
Moreover, the print area of the label paper or black mark paper if there is a print start position right under
label peeling position becomes "current label."
"Label peeling position" is the position where the label can be peeled off by hand. Details are different
depending on the model.
[Model-dependent variations]
Paper roll Printing paper commands
FS ( L p p
L H
1C 28 4C 02 00
28 40 76 2 0
× 256) = 2 (
p p
= 2, = 0)
H L H
Function
Feeds paper to the label peeling position. However, if the paper is in standby at the
label peeling position, the printer does not feed.
Feeds paper to the label peeling position. However, if the paper is in standby at the
label peeling position, the printer feeds paper to the next label peeling position.
TM-L90
fn m
m
41
m
65
FS ( L Ver. 10.01 p. 653