Disassembly Procedures
!
STACK DRYER SLOPED FRONT MODELS
Note:
The following section is exclusive to the stack
dryers.
Service Panel and Switch
1. Disconnect power to the machine.
2. Remove three security screws.
Service
Lock
Remove Security Screws
3. Unlock the service lock.
4. Pull the service panel down.
Service
Switch
50
WARNING
Wires
16022904 Rev. 0
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.
5. Disconnect wires to service switch.
Access Cover
1. Disconnect power to unit.
2. Remove the Access Panel.
3. Locate and remove the 5/16" hex head screw located
in the front of the dryer base frame . This screw
secures the access cover to the base frame.
Blower
Housing
4. Open the door.
5. Carefully slide the access cover down and away from
the machine to disengage the cover from retaining
clips on the front shroud located above the front panel
goal posts.
Control Panel
1. Disconnect power to the machine.
2. Remove the Access Panel.
3. Remove three security and two pozi drive screws
securing the Control Panel under the Console.
Screw
Access
Cover
Access Cover
Hook
©2004 Maytag Appliances Company