Reversing Door Assembly; Door Disassembly; Front Panel - Maytag MDE/MDG21PDA Service Manual

Disassembly Procedures
!

Reversing Door Assembly

Note: NOT ALL DOORS ARE REVERSIBLE
1. Disconnect power supply to unit.
2. Remove Door Assembly.
3. Remove the plastic hinge hole covers on the opposite side of the door opening.
4. Remove the hinges from the door itself and relocate them to the other side of the door.
5. Remount the door into the slots on the opposite side of the door opening in the front shroud and secure with one
screw into each hinge.
6. Mount the plastic hinge hole covers onto the side the hinges were previously on, to cover the slots in the front
shroud.

Door Disassembly

1. Disconnect power supply to unit.
2. Remove ten screws located across the bottom and along either side of the door panel. The top edge of the outer
panel is folded over the inner door plug.

Front Panel

1. Disconnect power supply to unit.
2. Open the door and remove the four screws along the
inside lip of the door opening.
Note: Two are located vertically on either side of the
door opening. These screws secure the front
panel to the front shroud assembly.
Remove
Four
Screws
©2004 Maytag Appliances Company
WARNING
Hinge
Hole
Cover
16022904 Rev. 0
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.
Hinge
Door
Catch
Inner Door
Cover
Cover Plate
3. Remove the two lower screws (T-25H Torx) securing
the front panel to the lower side flanges of the cabinet
assembly (If present).
Counter Sunk
Screw
Door
Screw
Door
Strike
Door
Screw
Remove
Two Screws
39