ATM/E3 Interface Management Window
Private VLAN Edge
The Private VLAN Edge area provides the following information:
•
•
•
Actions
The Actions area provides the following information:
•
•
ATM/E3 Tab
The following areas are available on the ATM/E3 tab of the ATM/E3 Interface Management window:
•
•
ATM
The ATM area contains the following information:
•
•
Cisco Catalyst Switch Manager User Guide
8-88
Status—Displays the status of private VLAN edge configuration on the interface. Status may be one
of the following values:
–
Enabled
–
Disabled
Not Applicable—VLANs are not supported on the device
–
Enable—Enables configuration of the private VLAN edge on the interface.
Disable—Disables configuration of the private VLAN edge on the interface.
Commission—This button is used to commission the object manually. This can only be done if the
object is in a decommissioned state. Clicking this button commissions the selected interface.
Decommission—This button is used to decommission the object manually. In the decommissioned
state, the properties of the object are not monitored. As a result, data displayed in the configuration
window is not guaranteed to be current. Clicking this button decommissions the interface.
ATM
E3
NSAP Address—Unique identifier of node in ATM network. This address is required if not
implemented by ATM CM.
End-Station ID—End-station ID of node in ATM network. The NSAP address prefix is provided by
the switch to the router through ILMI. There must be a PVC configured for ILMI communication
with the switch. This address is required if not implemented by ATM CM.
Chapter 8
Interface and Subinterface Management
OL-4930-01