Changing The Built-In Graphics Configuration Switches (Models 715/C, 715/33, 715/50, 715/75) - HP Model 715/100XC - Workstation Handbook

Changing the Built–In Graphics Configuration
Switches (Models 715/C, 715/33, 715/50, 715/75)
Figure 3–16 shows the built–in graphics configuration switch settings. Set the
switches according to the type of monitor that is connected to the system unit's built–
in graphics connector. First open the system unit, as described in Chapter 5, to allow
a clear view of the switches. Use a small probe to set the switches through the access
hole on the rear of the system unit.
NOTICE:
Figure 3–16. Changing the Graphics Configuration Switches
The built–in graphics configuration switches have no
affect on the operation of the optional CRX graphics
unit (if installed).
17" Color
19" Grayscale
15" Color
(Model 715/33 only)
Access Hole
20" Color
Configuration 3–17