PCX-T Module (Model 715/75)
Before removing the PCX-T module, perform the following steps:
Remove the optional external graphics processor (if installed).
Remove the floor stand.
Open the system unit.
Use a Phillips screwdriver to disconnect the internal grounding wire from the heat
sink, as shown in Figure 5–42. Move the grounding wire out of the carrier's way.
(You may also want to disconnect the grounding wire from the spade lug on the
processor board.)
Figure 5–42. Disconnecting the PCX-T Grounding Wire
CAUTION:
5–42
Field Replaceable Units
If you wish to disconnect the grounding wire from
the processor board, press down on the processor
board near the spade lug while removing the ground-
ing wire to prevent damage to the surrounding com-
ponents. Refer to the warning label on the grounding
wire.