System Unit Rear Panel Connectors
This section describes the following connectors on the system unit's rear panel:
SCSI connector
HP parallel I/O connector
HP–HIL connector (Model 715/C, 715/33, 715/50, and 715/75 workstations)
10–pin modular jack (Model 715/64, 715/80, 715/100, and 715/100XC
workstations)
RS–232 serial input/output connectors
802.3 network connector
Built–in graphics connector
Optional connector for EISA, CRX, or HCRX graphics
Power cord connector
Audio connectors
NOTICE:
Figure 1–3 shows the locations of the connectors on the system unit's rear panel. The
symbols shown are depicted on the rear panel.
To maintain FCC/EMI compliance, verify that all
cables are fully seated and properly fastened.
Product Information
1–7