NETGEAR WNR612v2 - Wireless-N 150 Router User Manual page 61

Wireless-N 150 Router WNR612v2 User Manual
To set up port triggering:
Select Port Forwarding/Port Triggering under Advanced in the main menu. The
1.
Forwarding/Port Triggering screen displays.
Select the Port Triggering radio button. The port triggering information displays.
2.
Clear the Disable Port Triggering check box.
3.
If the Disable Port Triggering check box is selected after you
Note:
configure port triggering, port triggering is disabled. However, any
port triggering configuration information you added to the router is
retained even though it is not used.
In the Port Triggering Timeout field, enter a value up to 9999 minutes. This value controls
4.
the inactivity timer for the designated inbound ports. The inbound ports close when the
inactivity time expires. This is required because the router cannot be sure when the
application has terminated.
Click Add. the Port Triggering–Services screen
5.
displays.
In the Service Name field, enter a descriptive
6.
service name.
In the Service User field, select Any (the default) to
7.
allow this service to be used by any computer on the
Internet. Otherwise, select Single address, and
enter the IP address of one computer to restrict the
service to a particular computer.
Select the service type, either TCP or UDP.
8.
In the Triggering Port field, enter the number of the
9.
outbound traffic port that will cause the inbound ports
to be opened.
Enter the inbound connection port information in the
10.
Connection Type, Starting Port, and Ending Port
fields.
Chapter 6: Fine-Tuning Your Network | 61