Hardware Features; Front Panel - NETGEAR WNR3500v2 - RangeMax Wireless N Gigabit Router Setup Manual

To ensure proper heat dissipation and for router stability, it is important that you
connect the stand and place your router in an upright position.

Hardware Features

Before you install and connect your router, take a moment to become familiar with important
information on the label, and with the front and back panels of the router—especially the status
lights on the front panel.

Front Panel

The router front panel, shown in
interpreting the status lights, see
Router Functions" on page
Figure 3
Getting to Know Your Wireless Router
Figure 3, contains status lights. (For more information on
"Verifying Your Connection" on page 18
32.)
Power
On – Amber
On – Green
Blink – Amber
Blink – Green
Off
Internet
On – Amber
On – Green
Blink – Green
Off
Wireless
On – Blue
Blink – Blue
Off
LAN (Ports 1–4)
On – Green
Blink – Green
On – Amber
Blink – Amber
Off
WPS button/light
Blink – Green
On – Green
The router is performing the power-on self-test diagnostic.
The power is on and the router is ready.
A software update is in progress.
The firmware is corrupt. See
Functions" on page 32
Power is not being supplied to the router.
No IP address acquired.
The wireless router has acquired an Internet address.
Data is being communicated with the Internet.
No Ethernet cable is connected to the modem.
The wireless interface is enabled.
Data is being communicated over the wireless network.
The wireless interface is turned off.
The local port is connected to a 1000 Mbps device.
Data is being transmitted at 1000 Mbps.
The local port is connected to a 10/100 Mbps device.
Data is being transmitted at 10/100 Mbps.
No link is detected on this port.
Indicates WPS activity; the device is in the 2 minute interval
to synchronize security or there is a WPS error.
Security set to WEP, WPA-PSK or WPA2-PSK.
and "Checking Basic
"Checking Basic Router
to restore your firmware.
3