NETGEAR WNR3500v2 - RangeMax Wireless N Gigabit Router Setup Manual page 21

Figure 11
Replace the Ethernet cable connected to your modem with the Ethernet cable that came with
4.
your router, and insert one end into the same port on the modem. Then, insert the other end
into the Internet port of your new router (F), as shown in
Start your network in the correct sequence, as described below.
5.
Failure to start or restart your network in the correct sequence could prevent you
from accessing the Internet.
To start your network:
Plug in the power and turn on the broadband cable modem or DSL modem. Wait 2 minutes.
1.
Plug the end of the power adapter cord into the wall or a power strip, and insert the other end
2.
into the power adapter outlet of your wireless router (G), shown in
Make sure that the Power button on the back of your router (H) is in the power-on state. (The
3.
button is depressed when in power-on mode.) Wait 1 minute.
Manually Installing Your Router
A
E
F
Figure 11.
Figure 12.
17