Teststaticentry; Pfc Layer 3 Forwarding Engine Tests - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Appendix A Online Diagnostic Tests

TestStaticEntry

The TestStaticEntry test verifies that static entries are populated in the Layer 2 MAC address table. This
functionality is verified during diagnostic packet lookup by the Layer 2 forwarding engine.
Table A-13
Attribute
Disruptive/Nondisruptive
Recommendation
Default
Release
Corrective action
Hardware support

PFC Layer 3 Forwarding Engine Tests

These are the PFC Layer 3 Forwarding Engine tests:
•
•
•
•
•
•
•
•
•
OL-11439-03
TestStaticEntry Test Attributes
TestFibDevices, page A-10
TestIPv4FibShortcut, page A-10
TestIPv6FibShortcut, page A-11
TestMPLSFibShortcut, page A-11
TestNATFibShortcut, page A-12
TestL3Capture2, page A-12
TestAclPermit, page A-13
TestAclDeny, page A-13
TestQoS, page A-14
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
Description
Disruptive for looped-back ports. Disruption is typically less
than one second. Duration of the disruption depends on the
configuration of looped-back port (for example, Spanning
Tree Protocol).
If you experience problems with the Layer 2 forwarding
engine learning capability, run this test on-demand to verify
the Layer 2 learning functionality. This test can also be used
as a health-monitoring test.
This test runs by default during bootup or after a reset or OIR.
12.2(18)ZY.
None. See the system message guide for more information.
Supervisor engines and DFC-enabled modules.
PFC Layer 3 Forwarding Engine Tests
A-9