Copying Files To The Redundant Supervisor Engine - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Chapter 6 Configuring RPR Supervisor Engine Redundancy
Command
Step 4
Router# hw-module {module num} reset
Step 5
Router# redundancy force-switchover
This example shows how to perform an FSU:
Router# config terminal
Router(config)# config-register 0x2102
Router(config)# boot system flash disk0:image_name
Router# copy running-config start-config
Router# hw-module reset
Router# redundancy force-switchover
Router#

Copying Files to the Redundant Supervisor Engine

Use the following command to copy a file to the disk0: device on a redundant supervisor engine:
Router# copy source_device:source_filename slavedisk0:target_filename
Use the following command to copy a file to the boot
Router# copy source_device:source_filename slavesup-bootdisk:target_filename
Use the following command to copy a file to the boot
Router# copy source_device:source_filename slavebootdisk:target_filename
OL-11439-03
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
Copying Files to the Redundant Supervisor Engine
Purpose
Reloads the redundant supervisor engine and brings it
back online (running the new version of the Cisco IOS
software).
Before reloading the redundant supervisor
Note
engine, make sure you wait long enough to ensure
that all configuration synchronization changes
have completed.
Conducts a manual switchover to the redundant
supervisor engine. The redundant supervisor engine
becomes the new active supervisor engine running the
new Cisco IOS image. The modules are reloaded and the
module software is downloaded from the new active
supervisor engine.
The old active supervisor engine reboots with the new
image and becomes the redundant supervisor engine.
To perform an EHSA to RPR FSU, use the reload
Note
command in Step 5.
: device on a redundant supervisor engine:
disk
: device on a redundant PISA:
disk
6-7