Pci Hot Plug; Network Interface Controller - HP DL760 - ProLiant - 1 GB RAM User Manual

Server Features

PCI Hot Plug

PCI Hot Plug provides the ability to remove, replace, upgrade, and add PCI/PCI-X
expansion boards without powering down the server. PCI and PCI-X boards can be
placed in a PCI Hot Plug slot. PCI Hot Plug device drivers and operating system
support are required to enable PCI Hot Plug.
A PCI Hot Plug button is located above each PCI/PCI-X slot, providing PCI Hot Plug
control directly at the server without the use of the PCI Hot Plug utility software.
For more information about PCI Hot Plug, refer to the server Documentation CD.

Network Interface Controller

The ProLiant DL760 G2 server ships with an NC7770 PCI-X Gigabit NIC
pre-installed in slot 11. This 10/100/1000 Base TX UTP, 64-bit, 133-MHz PCI-X
NIC includes the following features:
•
One RJ-45 connector for 10BaseT, 100BaseTX, or 1000BaseTX Ethernet
•
Pre-boot eXecution Environment (PXE) support
For information about the NIC, refer to the HP website:
www.hp.com
Redundant NIC software, located on the SmartStart CD, supports a redundant NIC
configuration. This feature may be used with one dual-port, two single-port, or two
dual-port NICs.
1-12 HP ProLiant DL760 Generation 2 Server User Guide