HP DL760 - ProLiant - 1 GB RAM User Manual page 287

Table E-9: Problems After Initial Boot
Problem
Server cannot load
the operating
system
HP ProLiant DL760 Generation 2 Server User Guide
continued
Possible Cause
Required operating system step
was missed.
Installation problem occurred.
Problem was encountered with
the hardware that you added to
the system.
Troubleshooting Information
Possible Solution
Follow these steps:
1. Note at which phase the operating
system failed.
2. Remove any loaded operating
system.
3. Refer to your operating system
documentation.
4. Reinstall the operating system.
Refer to your operating system
documentation and to the SmartStart
Release Notes on the SmartStart CD.
Use the ROM-Based Setup Utility to
troubleshoot where the installation
failed.
Refer to the documentation provided
with the hardware.
Run the ROM-Based Setup Utility to
determine if drives are properly attached
to the primary boot controller. Refer to
Chapter 6 for instructions about the
correct SCSI bus-cabling configuration
for your unit.
E-19