Enabling Ipv6 Vpn Access - Cisco 5505 - ASA Firewall Edition Bundle Administrator's Manual

Chapter 6 Configuring AnyConnect Features Using CLI
Figure 6-1
default webvpn timeout value is configured:
Figure 6-1
The following example configures the security appliance to prompt the remote user to download the
client or go to the WebVPN portal page and to wait 10 seconds for user response before downloading
the client:
hostname(config-group-webvpn)# svc ask enable default svc timeout 10

Enabling IPv6 VPN Access

The AnyConnect client allows access to IPv6 resources over a public IPv4 connection (Windows XP
SP2, Windows Vista, Mac OSX, and Linux only). You must use the command-line interface to configure
IPv6; ASDM does not support IPv6.
You enable IPv6 access using the ipv6 enable command as part of enabling SSL VPN connections. The
following is an example for an IPv6 connection that enables IPv6 on the outside interface:
hostname(config)# interface GigabitEthernet0/0
hostname(config-if)# ipv6 enable
To enable IPV6 SSL VPN, do the following general actions:
1.
2.
3.
4.
To implement this procedure, do the following steps:
Configure Interfaces:
Step 1
interface GigabitEthernet0/0
OL-12950-012
svc ask enable default webvpn timeout value prompts the remote user to download the client or
go to the WebVPN portal page, and waits the duration of value before taking the default
action—displaying the WebVPN portal page.
shows the prompt displayed to remote users when either default svc timeout value or
Prompt Displayed to Remote Users for SSL VPN Client Download
Enable IPv6 on the outside interface.
Enable IPv6 and an IPv6 address on the inside interface.
Configure an IPv6 address local pool for client assigned IP Addresses.
Configure an IPv6 Tunnel default gateway.
nameif outside
security-level 0
ip address 192.168.0.1 255.255.255.0
ipv6 enable ; Needed for IPv6.
Cisco AnyConnect VPN Client Administrator Guide

Enabling IPv6 VPN Access

6-3