NETGEAR DGN3500 - Wireless-N Gigabit Router Setup Manual page 29

:
Figure 16
• Entering a PIN. If you want to use the PIN method, select the PIN radio box. A screen
similar to the one shown below displays.
– Go to your wireless client and, from the client's WPS utility, obtain the wireless
client's security PIN, or follow the client's WPS utility instructions to generate a
security PIN.
– Then, enter this PIN in the Enter Client's PIN field provided on the router and click
Next. You have 2 minutes to enable WPS on the router using this method.
Figure 17
Using either method, the client wireless device will attempt to detect the WPS signal from the
router and establish a wireless connection in the time allotted.
• If no connection is detected, then no SSID or security settings are configured on the router.
• If a connection is established, the router WPS screen displays a message confirming that
the wireless client was successfully added to the wireless network. (The router has
generated an SSID, implemented WPA/WPA2 wireless security (including a PSK security
password) on the router and has sent this configuration to the wireless client.)
Configuring Your Wireless Network 25