Step 2: Standalone Configuration for PTZ Settings
Document 800-06554 Rev C
02/11
Figure 4-4
System Configuration Tab
1.
From the side menu, click Standalone Configuration (see
2.
Under DVR Setting drop-down list, set DVR type as same as the controlled DVR.
3.
Under Cascade Mode, the settings are used for cascading linkage of keyboards.
a.
Under Mode drop-down list, select Master or Slave for Ultrakey Touch.
b.
Under Master IP Address drop-down list, set the IP of the Master UltraKey
Touch.
4.
Under PTZ, set the address, name, and protocol for the controlled PTZ.
5.
Under Protocol Type drop-down list, select Diamond, PelcoD, PelcoP, VCL,
IntelliBUS protocol consistant with the controlled Ultrakey Touch.
6.
Click Apply to save the configuration, Cancel to exit without saving, or Default to
restore all factory default values.
UltraKey Touch Installation and User Guide
Figure
4-5).
57