Honeywell UltraKey Touch HJC4000 Installation And User Manual page 47

You want to...
Cycle through the cameras that are displayed
when viewing 2x2 and 3x3 displays
Set the screen layout of the multi-cameras,
and select a camera to be displayed in the
cameo
Start and stop a sequence
Freeze and unfreeze the current display
Select a camera
Reset an active alarm
Display the alarm event log
Note If user password is enabled on the DVR, then pressing Alarm will cause a user password screen to
display. If a user password is required, then enter the password as described on
Display a camera on the spot monitor
Apply the spot monitor to a camera sequence
Instant record or panic record
Open/close the Search menu
Play video
Switch between live monitoring and pause
Go to the next frame when the DVR is paused
Go to the previous frame when the DVR is
paused
Fast forward the DVR playback
Rewind DVR playback
Document 800-06554 Rev C
02/11
Table 3-9 Operating an HRXD DVR
UltraKey Touch Installation and User Guide
Do this...
Use the Slider_Left/Right.
Press Ent, then Slider_Up, Slider_Down, Slider_Left or
Slider_Right to select an active camera (highlight box
displayed). Press a number key + Camera, or Camera +
number + Ent, or number + Ent.
Press Seq to put the DVR output into a sequence (the
sequence depends on the current display mode and
setup). If the key is pressed again, the sequence will stop
(displaying the current step in the sequence).
Press F10.
Press number keys (to enter a valid camera number) +
Camera, or Camera + number + Ent, or number + Ent.
This will select a camera (identified by the number) for
full-screen display on the DVR output. This also selects the
associated DVR.
If an alarm is active, press Alarm to reset the DVR output
(internal buzzer included).
If the DVR is in live monitoring mode (and no alarm is
active), press Alarm to display the event log. Once the
event log is open, navigate through it in the same way as
described in Navigate the DVR
Press Monitor+number+Ent to choose a Spot Monitor,
then number + Camera, or Camera + number + Ent, or
number + Ent to select the camera that displays on that
spot monitor.
Press Monitor+number+Ent to choose a Spot Monitor,
and then Seq to apply the spot monitor to a camera
sequence.
Press Recycle to enable/disable the Panic Recording on
specified channel.
Press Search to bring up the Search menu. Press the key
again to exit the Search menu.
Press Review to playback or pause the DVR video.
Press the Stop key to switch between the live monitoring
and paused states.
Rotate the slider clockwise to show the next frame.
Rotate the slider counterclockwise to show the previous
frame.
Press Forward.
Press Backward.
menus, on page 46.
page 46.
47