Image Setup - D-Link DCS-3716 User Manual

Configuration
In this section, you may configure the video image settings for your camera. A preview of the image will be shown in Live Video.
Enable.Privacy. The Privacy Mask setting allows you to specify up to 3 rectangular areas on
Mask: the camera's image to be blocked/excluded from recordings and snapshots.
You may click and drag the mouse cursor over the camera image to draw a
mask area. Right-click on the camera image to bring up the following menu
options:
Disable.All: Disables all mask areas
Enable.All: Enables all mask areas
Reset.All: Clears all mask areas.
Mirror: Mirrors the images.
Rotates the image 180 degrees.
Flip:
White.Balance: If this option is enabled, white objects will be rendered as white on the screen.
Changes the exposure mode. Use the drop-down box to set the camera for
Exposure.Mode:
Indoor, Outdoor, or Night environments, or to capture Moving objects. The
Low Noise option will focus on creating a high-quality picture without noise.
You can also create 3 different custom exposure modes. The Max Gain setting
will allow you to control the maximum amount of gain to apply to brighten the
picture.
Denoise: This setting controls the amount of noise reduction that will be applied to the picture.
Brightness: Adjust this setting to compensate for backlit subjects.
Contrast: Adjust this setting to alter the color intensity/strength.
Saturation: This setting controls the amount of coloration, from grayscale to fully saturated.
Sharpness:. Specify a value from 0 to 8 for image edge enhancement.
WDR.Level: Adjust the wide dynamic range level from 0 to 8; higher settings are better for high-contrast environments.
Reset.Default: Click this button to reset the image to factory default settings.
D-Link DCS-3716 User Manual

Image Setup

28