Hardware Reset; Camera Usage Notes - Cisco PVC300 - Small Business Pan Tilt Optical Zoom Internet Camera Network Administration Manual

Getting to Know the PVC300 PTZ Internet Camera

Camera Usage Notes

Camera Usage Notes
Cisco Small Business Administration Guide for the Model PVC300 PTZ Internet Camera with Audio and PoE

Hardware Reset

There is an indented reset button on the back panel of the PVC300 PTZ Internet
Camera. It is used to reboot the PVC300 PTZ Internet Camera or restore it to the
factory default. Sometimes rebooting the PVC300 PTZ Internet Camera can set it
back to normal state. If the problems remain after rebooting, restore the factory
default and install again.
Reboot—Press and release the indented reset button with a paper clip. Wait for
the PVC300 PTZ Internet Camera to reboot.
Restore—Press the indented reset button continuously for around 30 seconds
until the status LED rapidly blinks amber and green simultaneously. Note that all
settings will be restored to factory default.
The use of surveillance devices may be prohibited by law in your country. It is your
responsibility to ensure that the operation of such devices is legal before installing
this unit for its intended use. It is important to first verify that all contents received
are complete as listed in the Quick Start Guide.
Carefully read and follow the instructions in
avoid damages due to faulty assembly and installation. This also ensures the
product is used properly as intended.
Chapter 2, "Installing The Camera,"
1
to
11