Wheel Alignment - Grizzly EXTREME G0514X2 Owner's Manual

Wheel Alignment

Components and Hardware Needed:
60" Long 2x4 ..................................................... 1
Tools Needed:
Wrench 13mm ................................................... 1
Tape Measure ................................................... 1
Coplanarity Gauge (see Figure 62) .................. 1
Wheel alignment is one of the most critical factors
for optimal performance from your bandsaw.
Heat, vibration, wandering, blade wear, tire wear
and overall bandsaw wear are considerably
decreased when the wheels are properly aligned
or "coplanar."
Coplanar wheels automatically track the blade
by balancing it on the crown of the wheel. This is
known as coplanar tracking.
To check if your wheels are coplanar:
1.
Make the "Coplanarity Gauge" shown in
Figure 62. Note: For best results, straighten
the 2x4 with a jointer before cutting.
2. Remove the fence and table, then open both
wheel covers.
3.
Make sure the guide blocks and rear sup-
port bearings are away from the blade, then
tighten your blade to the tension that it will be
used during operation.
4.
Place your coplanarity gauge up against both
wheels in the positions shown in Figure 63.
G0513X/G0514X/G0514X3 Extreme Series Bandsaw
Qty
���
��
���
���������
Figure 62. Dimensions of coplanarity gauge.
Tracking
Knob
Adjustment
Hub
Figure 63. Checking for coplanarity.
������
������������
��������������������
���
������
������������
��������������������
Coplanarity
Gauge Positions
Gauge
Wheels
-51-