Grizzly G0449 Owner's Manual page 50

6.
Remove the front and rear upper frame
angles (4 cap screws, 4 lock washers, and 4
flat washers on each one).
7. Remove the table height lock knob.
8. Remove the feed motor cover (4 button head
screws and setscrew on knob).
9. Remove the front conveyor guard (4 button
head screws) and the cord clamp, and set
the front conveyor guard off to the side of the
machine.
10. Remove the rear conveyor end guards (4 but-
ton head screws). The drum sander should
now look similar to Figure 69.
Figure 69. Drum sander disassembled
to Step 11.
-48-
11. Raise the table up to the 1" mark on the
scale.
12. Mark the position of the chain and sprock-
ets.
13. Loosen the chain idler adjustment sprocket,
carefully pull the chain off of all the sprockets,
and remove it from the cabinet by undoing
the chain master link, as shown in Figure
70.
Figure 70. Chain removed from table by
removing the master link.
14. Loosen the conveyor belt from the rear
adjustments, as shown in Figure 71.
Figure 71. Conveyor belt loosened at the rear
adjustment.
G0449/G0450 37" Drum Sander