Placing Sander - Grizzly G0449 Owner's Manual

9.
With assistance, lift the control panel into
place and secure it with the bolts, flat wash-
ers, and hex nuts removed in Step 7.
10. Reinstall the right access panel.
11. Attach the brace from the control panel to the
sander as shown in Figure 12.
Figure 12. Control panel brace.
12. Place the handwheel over the shaft shown
in Figure 13 and tighten the set screw in the
handwheel hub.
Figure 13. Handwheel installed.
G0449/G0450 37" Drum Sander

Placing Sander

The Model G0449/G0450
has a shipping weight
over 1200 lbs. Serious
personalinjurymayoccur
if safe moving meth-
ods are not followed. To
be safe, get assistance
and use power equip-
ment when moving the
crate and removing the
machine from the crate.
Use lifting straps with a combined minimum
of 2000 lbs. lifting capacity. If lifting straps
break, serious personal injury may occur.
To place the sander in a permanent location:
1. Unbolt the sander from the pallet.
2. Position the forklift forks directly above the
sander. Place two lifting straps with hooks on
the ends over the forklift forks and slide the
hooks into the points shown in Figure 14.
Figure 14. Lifting the sander.
3. Lift the sander and move it to your predeter-
mined location. DO NOT lift it any higher than
is necessary to clear the floor.
-17-