User - Linksys RTP300 - Broadband Router With 2 Phone Ports Administration Manual

Field Description
Ring Frequency Max Maximum ring frequency to detect. The range is 5-100.
The default is 100.
Ring Validation Time Choose from {100, 150, 200, 256, 384, 512, 640, 1024} (ms).
The default is 256ms.
Ring Indication Delay Choose from {0, 512, 768, 1024, 1280, 1536, 1792} (ms).
The default is 512ms.
Ring Timeout Choose from {0, 128, 256, 384, 512, 640, 768, 896, 1024, 1152, 1280, 1408,
1536, 1664, 1792, 1920} (ms).
The default is 640 ms.
Ring Threshold Choose from {13.5–16.5, 19.35–2.65, 40.5–49.5} (Vrms).
The default is 13.5-16.5 Vrms.
Ringer Impedance Choose from {High, Synthesized(Poland, S.Africa, Slovenia)}.
The default is high.
Line-In-Use Voltage Determines the voltage threshold at which the SPA-3000 assumes the PSTN
is in use by another handset sharing the same line (and will declare PSTN
gateway service not available to incoming VoIP callers).
The default value is 40v.
Voice tab >
User page
Depending on the model of ATA device, there may be one or more User pages. You can use this
page to configure the user settings. This page includes the following sections:
• "Call Forward Settings section" section on page 157
• "Selective Call Forward Settings section" section on page 157
• "Speed Dial Settings section" section on page 158
• "Supplementary Service Settings section" section on page 158
• "Distinctive Ring Settings section" section on page 159
• "Ring Settings section" section on page 159
NOTE: For the SPA8000, the settings on this page occur on each Line tab ([1] to [8]).
When a call is made from Line 1 or Line 2, the ATA device shall use the user and line settings for
that line; there is no user login support. Per user parameter tags must be appended with [1] or
[2] (corresponding to line 1 or 2) in the configuration profile. It is omitted below for readability.
Linksys ATA Administration Guide
User page
156