Adjusting The Projector Elevation Angle; Rear Projection (From The Back Of The Screen - Casio SC-210 User Manual

Getting Ready

Adjusting the Projector Elevation Angle

You can change the elevation angle of the projector in a range of 0 to 12 degrees. You can
also make fine adjustments to the left and right side elevation angle when necessary.
To change the projector elevation angle
1.
Lift up the front of the projector and press the
release button.
This causes the elevation adjustment foot to drop
from the bottom of the projector.
Be sure to press the release button before trying to
lower the elevation adjustment foot. Pulling on the
foot without pressing the release lever can damage
the foot.
2.
While holding down the release button, raise and
lower the front of the projector until the elevation adjustment foot is approximately the
length you need.
3.
Release the release button to lock the elevation adjustment foot in its current position.
4.
Use the left and right adjustment feet to further fine adjust the elevation angle.
The left and right adjustment feet are for fine adjustment only. Do not try to rotate them
too far. Doing so can cause an adjustment foot to detach. Tightening an adjustment foot
too strongly can cause it to become stuck.
To retract the elevation adjustment foot, hold down the release button and slide the
elevation adjustment foot back into the projector. Never try to forcibly change the elevation
adjustment foot position without pressing the release button.

Rear Projection (From the Back of the Screen)

In the case of rear projection, left/right orientation is opposite that of front projection, so you
need to configure the setup menu accordingly. For more detailed operation information, see the
User's Guide (UsersGuide_English.pdf) on the CD-ROM that comes with the projector.
Rotate to adjust horizontal alignment.
E-16