Figure 5-1 Component Tray Removal For Chassis With A Safety Latch - Cisco EF4116 Hardware Installation And Maintenance Manual

Figure 5-1
Rear of chassis
Step 6
Step 7
Removing the Component Tray from a Chassis without a Safety Latch
Warning
working near the power supply. Before starting any of these procedures, turn off power to the
system, unplug the power cord, disconnect any cables at the ports, and connect your ESD-preventive
wrist strap.
Follow these steps to remove the component tray from a chassis without a safety latch.
Step 1
Step 2
Step 3
Step 4
Component Tray Removal for Chassis With a Safety Latch
Chassis shell
AUX
While supporting the component tray with one hand, push down on the safety latch tab
while pulling out on the component tray.
Set the component tray on your work surface.
Hazardous voltages may exist in or near the power supply, so use extreme caution when
Turn off the system power.
Put on your ESD-preventive wrist strap.
Remove all network and power cables.
Loosen the (nonremovable) screw in the back of the router chassis, labeled Chassis release
screw in Figure 5-2.
Safety latch tab
Chassis release
screw
CONSOLE
INPUT 100-240VAC
Hand supporting
component tray
Accessing the Router Internal Components
50/60HZ 3.0-1.5 AMPS
Handle
Maintaining and Upgrading the Router 5-3