Figure 5-12 Inserting Flash-Memory Simms - Cisco EF4116 Hardware Installation And Maintenance Manual

Memory Replacement Procedures
Figure 5-12
3.
4.
3.
4.
Caution
the surface components to avoid damaging them.
Step 4
If you have completed all memory upgrade procedures, proceed to the section "Replacing Network
Processor Modules" later in this chapter.
5-18 Cisco 4000 Series Hardware Installation and Maintenance
Inserting Flash-Memory SIMMs
1. Insert the SIMM into the socket at an angle 45 from vertical.
2. Push the SIMM down and back.
The socket guide posts insert
through the SIMM holes
(on both sides).
The locking spring will
clip the front side of the SIMM
when it is fully installed
(on both sides).
1. Insert the SIMM into the socket at an angle 45 from vertical.
The socket guide posts insert
through the SIMM holes
(on both sides).
The locking spring will
clip the front side of the SIMM
when it is fully installed
(on both sides).
You will feel some resistance, but do not use excessive force on the SIMM and do not touch
Check the alignment of each SIMM to make sure that it is straight and that the alignment
holes are lined up with the plastic socket guides.
Top view
Front of the chassis
Side view
2. Push the SIMM down and back.
Polarization
notch