Configure Radio Station Subinterfaces - Cisco 520-T1 - Small Business Pro SR Secure Router Software Configuration Manual

Chapter 9 Configuring a Wireless LAN Connection
Command or Action
Step 3
bridge-group number
Example:
Router(config-if)# bridge-group 1
Router(config-if)#
Step 4
bridge-group parameter
Example:
Router(config-if)# bridge-group 1
spanning-disabled
Router(config-if)#
Step 5
interface name number
Example:
Router(config-if)# interface bvi 1
Router(config-if)#
Step 6
ip address address mask
Example:
Router(config-if)# ip address 10.0.1.1
255.255.255.0
Router(config-if)#
Repeat

Configure Radio Station Subinterfaces

Perform these steps to configure subinterfaces for each root station, beginning in global configuration
mode:
Command
Step 1 interface type number
Example:
Router(config)# interface dot11radio 0.1
Router(config-subif)#
Step 2 description string
Example:
Router(config-subif)# description Cisco open
Router(config-subif)#
OL-14210-01
Step 2 through Step 6 above for each VLAN that requires a wireless interface.
Purpose
Assigns a bridge group to the interface.
Sets other bridge parameters for the bridging
interface.
Enters configuration mode for the virtual bridge
interface.
Specifies the address for the virtual bridge
interface.
Purpose
Enters subinterface configuration mode for the
root station interface.
Provides a description of the subinterface for
the administrative user.
Cisco Secure Router 520 Series Software Configuration Guide
Configure Radio Station Subinterfaces
9-5