Configure The Fast Ethernet Wan Interfaces - Cisco 520-T1 - Small Business Pro SR Secure Router Software Configuration Manual

Chapter 3 Configuring PPP over Ethernet with NAT
Command or Action
Step 3
request-dialin
Example:
Router(config-vpdn)# request-dialin
Router(config-vpdn-req-in)#
Step 4
protocol {l2tp | pppoe}
Example:
Router(config-vpdn-req-in)# protocol pppoe
Router(config-vpdn-req-in)#
Step 5 exit
Example:
Router(config-vpdn-req-in)# exit
Router(config-vpdn)#
Step 6 exit
Example:
Router(config-vpdn)# exit
Router(config)#

Configure the Fast Ethernet WAN Interfaces

In this scenario, the PPPoE client (your Cisco router) communicates over a 10/100 Mbps-Ethernet
interface on both the inside and the outside.
Perform these steps to configure the Fast Ethernet WAN interfaces, starting in global configuration
mode:
Command
Step 1
interface type number
Example:
Router(config)# interface fastethernet 4
Router(config-if)#
Step 2 pppoe-client dial-pool-number number
Example:
Router(config-if)# pppoe-client
dial-pool-number 1
Router(config-if)#
OL-14210-01
Configure the Fast Ethernet WAN Interfaces
Purpose
Creates a request-dialin VPDN subgroup,
indicating the dialing direction, and initiates the
tunnel.
Specifies the type of sessions the VPDN subgroup
can establish.
Exits request-dialin VPDN group configuration.
Exits VPDN configuration, returning to global
configuration mode.
Purpose
Enters interface configuration mode for a
Fast Ethernet WAN interface.
Configures the PPPoE client and specifies the
dialer interface to use for cloning.
Cisco Secure Router 520 Series Software Configuration Guide
3-3