Cisco 520-T1 - Small Business Pro SR Secure Router Software Configuration Manual page 90

Software guide
Table of Contents

Advertisement

Figure 8-1
Figure 8-1
1
1
Multiple networked devices—Desktops, laptop PCs, switches
2
Fast Ethernet LAN interface (the inside interface for NAT)
3
PPPoE or PPPoA client and firewall implementation—Cisco Secure Router 520 Series router
4
Point at which NAT occurs
5
Protected network
6
Unprotected network
7
Fast Ethernet or ATM WAN interface (the outside interface for NAT)
In the configuration example that follows, the firewall is applied to the outside WAN interface (FE4) and
protects the Fast Ethernet LAN on FE0 by filtering and inspecting all traffic entering the router on the
Fast Ethernet WAN interface FE4. Note that in this example, the network traffic originating from the
corporate network, network address 10.1.1.0, is considered safe traffic and is not filtered.
Configuration Tasks
Perform the following tasks to configure this network scenario:
Configure Access Lists
Configure Inspection Rules
Apply Access Lists and Inspection Rules to Interfaces
A configuration example that shows the results of these configuration tasks is provided in the
"Configuration Example" section on page
Cisco Secure Router 520 Series Software Configuration Guide
8-2
shows a network deployment using PPPoE or PPPoA with NAT and a firewall.
Router with Firewall Configured
4
2
3
5
6
Chapter 8
7
8-5.
Configuring a Simple Firewall
OL-14210-01

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents