Configure Global Parameters; Configure Fast Ethernet Lan Interfaces; Configure Wan Interfaces - Cisco 520-T1 - Small Business Pro SR Secure Router Software Configuration Manual

Configuring Basic Parameters

Configure Global Parameters

Perform these steps to configure selected global parameters for your router:
Command
Step 1 configure terminal
Example:
Router> enable
Router# configure terminal
Router(config)#
Step 2 hostname name
Example:
Router(config)# hostname Router
Router(config)#
Step 3 enable secret password
Example:
Router(config)# enable secret cr1ny5ho
Router(config)#
Step 4
no ip domain-lookup
Example:
Router(config)# no ip domain-lookup
Router(config)#
For complete information on the global parameter commands, see the Cisco IOS Release 12.3
documentation set.

Configure Fast Ethernet LAN Interfaces

The Fast Ethernet LAN interfaces on your router are automatically configured as part of the default
VLAN and as such, they are not configured with individual addresses. Access is afforded through the
VLAN. You may assign the interfaces to other VLANs if desired. For more information about creating
VLANs, see

Configure WAN Interfaces

The Cisco Secure Router 520 Ethernet-to-Ethernet routers have one Fast Ethernet interface for WAN
connection. The Cisco Secure Router 520 ADSL-over-POTS and Cisco Secure Router 520
ADSL-over-ISDN routers have one ATM interface for WAN connection.
Cisco Secure Router 520 Series Software Configuration Guide
1-4
Chapter 5, "Configuring a LAN with DHCP and VLANs."
Chapter 1
Purpose
Enters global configuration mode, when using the
console port.
If you are connecting to the router using a remote
terminal, use the following:
telnet router name or address
Login: login id
Password: *********
Router> enable
Specifies the name for the router.
Specifies an encrypted password to prevent
unauthorized access to the router.
Disables the router from translating unfamiliar
words (typos) into IP addresses.
Basic Router Configuration
OL-14210-01