Chapter 4 - Data Editing; Prefix/Suffix Overview; To Add A Prefix Or Suffix - Honeywell 3800gPDF - Hand Held Decoding Linear Imager User Manual

4
Data Editing

Prefix/Suffix Overview

When a bar code is scanned, additional information is sent to the host computer
along with the bar code data. This group of bar code data and additional,
user-defined data is called a "message string." The selections in this section
are used to build the user-defined data into the message string.
Prefix and Suffix characters are data characters that can be sent before and
after scanned data. You can specify if they should be sent with all symbologies,
or only with specific symbologies. The following illustration shows the break-
down of a message string:
Points to Keep In Mind
• It is not necessary to build a message string. The selections in this chapter
are only used if you wish to alter the default settings. Default prefix = None.
Default suffix = None .
• A prefix or suffix may be added or cleared from one symbology or all
symbologies.
• You can add any prefix or suffix from the
1252) on page A-3, plus Code I.D. and AIM I.D.
• You can string together several entries for several symbologies at one time.
• Enter prefixes and suffixes in the order in which you want them to appear on
the output.

To Add a Prefix or Suffix

Step 1. Scan the Add Prefix or Add Suffix symbol
Step 2. Determine the 2 digit Hex value from the Symbology Chart (included in
Appendix
suffix. For example, for Code 128, Code ID is "j" and Hex ID is "6A".
Step 3. Scan the 2 hex digits from the
cover of this manual or scan 9, 9 for all symbologies.
Prefix
Scanned Data
1-11 variable length
alpha numeric
characters
A) for the symbology to which you want to apply the prefix or
Suffix
1-11
alpha numeric
characters
ASCII Conversion Chart (Code Page
(page
Programming Chart
4-3).
inside the back
4 - 1