Keyboard Wedge Connection - Honeywell 3800gPDF - Hand Held Decoding Linear Imager User Manual

3. Connect the appropriate interface cable to the imager and to the terminal/
computer.
4. Turn the terminal/computer power back on.
Note: You will not hear a power-up beep because the 3800g is factory defaulted
to a USB connection. You must scan the
with CR suffix
Verify the imager operation by scanning a bar code from the
the back of this manual. The imager beeps once.

Keyboard Wedge Connection

Scanning the bar code below allows operation of the 3800g as a keyboard
wedge interface to an IBM PC AT with a U. S. keyboard.
If you programmed the imager for a different terminal interface and you want to
change to an IBM PC AT and compatibles keyboard wedge interface, scan the
bar code below.
Note: The following bar code also programs a carriage return (CR) suffix.
bar code on page 1-5
IBM PC AT and Compatibles
with CR suffix
IBM PC AT and Compatibles
to enable keyboard wedge ability.
Sample Symbols in
1 - 5