Chapter 9 - Utilities; To Add A Test Code I.d. Prefix To All Symbologies; Show Software Revision; Show Data Format - Honeywell 3800gPDF - Hand Held Decoding Linear Imager User Manual

9
Utilities

To Add a Test Code I.D. Prefix to All Symbologies

This selection allows you to turn on transmission of a Code I.D. before the
decoded symbology. (See the Symbology Chart, included in the "Appendix
A" on page A-1) for the single character code that identifies each symbology.)
This action first clears all current prefixes, then programs a Code I.D. prefix for
all symbologies. This is a temporary setting that will be removed when the unit
is power cycled.
Add Code I.D. Prefix to
All Symbologies (Temporary)

Show Software Revision

Scan the bar code below to output the current software revision, unit serial num-
ber, and other product information.
Show Revision

Show Data Format

Scan the bar code below to show current data format settings.
Data Format Settings

Resetting the Standard Product Defaults

If you aren't sure what programming options are in your imager, or you've
changed some options and want the standard product default settings restored,
scan the Standard Product Default Settings bar code below.
Standard Product Default Settings
The Menu Commands starting on page 11-5 lists the standard product default
settings for each of the commands (indicated by an asterisk (*) on the program-
ming pages).
9 - 1