Start A Print; Stop A Print - Brother GTX600 NB Instruction Manual


Menu
Adjust platen height
Head Cleaning
Test Print
Ink refill
Print Data Load
A
B
C
D
E
If the obstacle sensor detects any intereference, the platen will be lowered automatically 3 times. If
there is still any obstacle after the third time, the print will be canceled. There is also a platen too low
sensor to prevent excessive ink mist.
The maximum possible setting for the platen height is 30 mm, what would result in an 34,3 mm
distance between the platen surface and the printheads.

START A PRINT

3.4


STOP A PRINT

3.5


4.3 mm
4.9 mm
5.7 mm
6.7 mm
8.3 mm
When the (preatreated) garment has been mounted
on the plate and the printfile has been loaded, the
print is started by pressing the two green buttons
simultaneously.
Press it for at least 0.5 seconds. There will be an
acoustic signal for the platen run-in. Wait until the
second acoustic signal, otherwise the print will get
canceled. Then release the green buttons.
To cancel a print, press any of the black buttons.
It is enough to press one of the two buttons.
The printing process will stop immediately.
The platen movement will stop for safety reasons.
The printhead carriage will move into capping
position.
To move the platen out of the printer, press the
platen movement button on the control panel.
Adjust platen height
Position A
Position B
Position C
Position D
Position E
F
G
H
CUSTOM 1
CUSTOM 2
9.8 mm
11.8 mm
14.3 mm
Defined by user
Defined by user
10 / 27