Chapter 3 - Honeywell Printer Commands; Allow Messages From Printer Quit Esc/P - Honeywell RP2F Series User Manual

CHAPTER
3
These commands are specific to Intermec printers and allow you to set some of the
same commands as Intermec Settings, retrieve printer information, or quit EZ Print:
Allow Messages From Printer
l
Quit ESC/P
l
Restore Factory Defaults
l
Retrieve Firmware Version
l
Retrieve Job Status
l
Retrieve Printer Status
l
Retrieve Sleep and Standby Timer Values
l
Set Dark Adjust
l
Set Low Battery Indicator
l
Set Media Sensitivity
l
Set Print Speed
l
Set Sleep and Standby Timers
l
Allow Messages From Printer
Turns on or off the ability to see error messages the printer generates to alert a user of an error
condition. Each error is only sent once from the printer.
Command
ESC{SSC:U:x}
where:
x is:
Y: Turns on the allow messages from printer command.
N (default): Turns off the allow messages from printer command.
Example
This command turns on the allow messages from printer option.
ESC{SSC:U:Y}
EZ-Print Command Reference
HONEYWELL PRINTER
COMMANDS
63