Set Roam - Honeywell RP2F Series User Manual

Only users with administrative privileges can set this command.
Command
ESC{SWF:P2:<sexp>}ESC EZ{COMMIT}{LP}
where values for <sexp> are:
0 (default): Constant Awake Mode (CAM)
1: Power Saving (PS)
2: Fast Power Saving (FAST)
Setting the Power Mode to "1" or "2" saves more battery life but could impact network
connection reliability.
Example
This command sets the printer to Power Saving Mode.
ESC{SWF:P2:1}ESC EZ{COMMIT}{LP}
Returns this reply if the command is not successful:
{SWF:P2:1}
Returns this reply if the command is successful:
{SWF:P2:0}

Set Roam

Sets the roaming behavior of the printer. In an environment with several access
points, the network adapter may have difficulty determining which access point to
connect to. To make the network adapter less inclined to switch access points, you
can change the Roaming Bias. A higher Roaming Bias value makes the network
adapter less inclined to roam. The roaming settings are based on the RSSI (Received
Signal Strength) of the device.
Only users with administrative privileges can set this command.
Command
ESC{SWF:R:<sexp>}ESC EZ{COMMIT}{LP}
where values for <sexp> are:
0 (off): Trigger: -99 dBm, Signal: 1
1: Trigger: -60 dBm, Signal: 40
2: Trigger: -70 dBm, Signal: 40
3: Trigger: -80 dBm, Signal: 20
54 EZ-Print Command Reference